Veteran-Owned · MA Master Plumber PL17071-M · 24/7 No-Heat Service
Heating Repair & Installation in Kingston, MA
Kingston is a split-fuel town. Natural gas runs along parts of the 3A and Route 53 corridors, but a large share of the town still heats with oil or propane. Which side of that line your house falls on changes the entire replacement conversation — and it is the first thing we check before quoting anything.
No heat in Kingston? Call (781) 974-5239 — a real person answers around the clock. If you smell gas or oil, leave the house first and call from outside.
Three honest paths for a Kingston heating replacement
If gas is at the street: a high-efficiency condensing gas boiler or furnace is usually the lowest-operating-cost answer, and an oil-to-gas conversion can pay back quickly. We coordinate the utility, run the gas piping, handle the equipment and take care of oil tank removal as one project rather than three.
If you are on oil or propane with no gas nearby: this is where a cold-climate heat pump genuinely competes. Kingston is on an investor-owned utility, so the full Mass Save incentives apply here — and they are aimed squarely at homes exactly like yours. We will run the real numbers against a new oil or propane unit instead of assuming the answer.
If the equipment can be saved: we will tell you. A twelve-year-old boiler with a failed circulator is a repair, not a replacement, and we would rather do the repair and earn the replacement later.
Freeze protection for seasonal homes
Rocky Nook and the shore-side streets have plenty of homes that sit empty for stretches of winter. The heating system is the only thing standing between an empty house and a burst pipe. For those properties we set low-limit protection, verify the system will actually restart after a power outage, and can add remote temperature monitoring so you know the moment heat is lost rather than in April.
What we handle in Kingston
- Heating repair and no-heat service — gas, oil, propane and heat pumps, 24/7.
- Boiler repair and service — cast iron and high-efficiency, circulators, zone valves, leaks and kettling.
- Boiler replacement and furnace replacement — right-sized to a heat loss calculation, not to the label on the old unit.
- Oil-to-gas conversions — utility coordination, piping, equipment and tank removal handled together.
- Annual maintenance and tune-ups — combustion testing and safety checks that prevent the January call and protect your warranty.
- Navien combi boilers and tankless — we are a Navien Certified contractor.
Kingston questions we hear
Is gas available on my street? We check before we quote. If it is close but not at your property, we will tell you what the utility extension realistically involves rather than leaving you to find out after you have committed.
My boiler is 25 years old but still runs — should I wait? A boiler that age is running at a fraction of modern efficiency and will fail on the coldest night of the year, which is the worst time to make a rushed decision. Planning the replacement in the fall gets you a better system and a calmer choice.
Will a heat pump actually keep up in a Kingston winter? Properly sized cold-climate equipment holds capacity well below zero. The failures you have heard about are almost always undersized systems or bad commissioning. See our heat pump owner’s guide for how they are meant to be run.
Also in Kingston: plumbing · cooling and heat pumps · all Kingston services
Heating nearby: Plymouth · Duxbury · Pembroke · Halifax
3R Plumbing & Mechanical LLC · 77 Accord Park Drive, Suite D6, Norwell, MA · MA Master Plumber PL17071-M